How To Loosen a Garage Door Spring?

Garage Door Installation Wake Forest NC

Loosen a Garage Door Spring

These springs provide the power and direction. The springs exert a force equal in weight to your garage door. When the motor turns on, the energy of the spring lifts it. If the motor pushes down the springs let the door lower.

To make the system work, the springs need to be correctly calibrated. They must exert a force equal to or greater than the door’s weight. The motor will be taxed if they aren’t pulling enough force or the door won’t raise. The door may be damaged if it is pushed too hard.

These springs are rarely an issue. However, every now and again, springs can burst, and they will need replacing.

How to Replace a Torsion Spring

The simple answer is to call a professional to replace it. This is the most hazardous element of maintaining an automatic garage door.

This is due to the tension that springs are under. These springs are counter-balanced, as stated above. They are normally wound to a tension that counterbalances 100 to 200 pounds. If the spring is released or unwound, it can snap with all the force of the tension. Flying metal at this speed can cause severe damage, including the possibility of ripping flesh, breaking bones, or even killing. It is essential to have the right tools, as well as safety precautions. A safety helmet, protective eyewear, and gloves are crucial. Contact our Experts at Garage Door Installation Wake Forest NC

The following method replaces torsion springs without going into too many details, which is beyond this article’s scope.

You must ensure that you have the right replacement springs. Measure to verify the length of the springs and never use an incorrect replacement.

Unplug the motor assembly and let the garage door open

Place your springs on both the right and left sides of the door. Mark your torsion shafts by measuring them.

Use the appropriate equipment to unwind the spring. Assume that the spring will burst and take the necessary precautions. A winding bar should be at least 18 inches in length.

This is where the torsion hardware can be removed and replaced with new springs. The torsion pole is then re-positioned and the springs adjusted to the right level.

There are many places that provide step-by-step instructions. It is best to have an experienced, licensed service representative replace your torsion springs. It is very dangerous to attempt to replace a spring on your garage door.

Leave a Comment

Your email address will not be published. Required fields are marked *